Cabletron Systems FRM User Manual - page 302
20-2
Frame Relay Module 4. 0 User G uide, Rev 01
●
Retransmitted frames per sec (*10)
– is the number of frames retransmitted by the
RLP per second over the five-second reporting interval, multiplied by 10. If the
value is consistently greater than zero and there are no other problems, you
should increase the
T1
timer (
Retransmission Period
) in the Port record.
Configuring RLP Statistics Thresholds
For each RLP statistic, you can specify a threshold that, when crossed, causes an alarm
to be sent to the collecting node.
Press
[A]
at the Statistics Menu. When prompted, enter:
●
Statistic level
:
L
for RLP.
●
RLP
:
0
on FRM/2/3,
0–2
on FRM. (Default is
0
.)
A menu similar to the following figure will be displayed.
Figure 20-2 RLP Statistics Configuration Menu
[E],[A]
from Main Menu
Changing a threshold changes the database value. Press
[F7]
to write the
change to system memory.
A threshold is either a number or a percentage, depending on the statistic. The valid
range for any statistic is
0–65535
. (Default =
0.
) When the measured value for the sta-
tistic crosses the threshold (in either direction), an alarm is generated.
Nod e Name=n ode_xyz
R LP Statistics (Th resh old s)
R LP: 0
Datab ase
Sys tem Memory
A Percentage of Buffers in Us e
0
0
B Numb er of Queued Mess ages
0
0
C Received frames/Sec (*10)
0
0
D Tran smitted frames/Sec (*10)
0
0
E Rejected frames/Sec (*10)
0
0
F Retran smitted Frames /S ec (*10)
Option: