Cabletron Systems FRM User Manual - page 243
Configuring Bridging
15-11
A MAC filter will be applied to LLC2 traffic whether or not bridging
is enabled (in
Bridge Node Defaults
). Other filter types will be
applied only if bridging is enabled.
●
Direction
:
i
(inbound) or
o
(outbound). (The default is
o
.)
●
Any other requested information, referring to
Table 15-7
.
Figure 15-3 Typical Bridge Filter Applications Record
[A],[A],[E],[F],[I]
from Main Menu
Up to 100 filters can be configured, displayed over ten "pages" (screens).
[PgDn]
and
[PgUp]
can be used to move through the screens. (At any screen, pressing
[F3]
will save
the configuration for all ten screens and exit the display. Pressing
[Esc]
at any screen
will abandon the changes for all ten screens and exit.)
When finished configuring filter definitions and applications, you must perform an
on-line update to make the changes effective immediately. Press
[J]
at the Filter Def-
initions and Applications Configuration Menu. The changes will be sent to the
software running on the RLPs.
Permit
Determines whether the traffic defined by the
Filter "n"
entries will be permitted or
denied passage across the interface.
Table 15-7 Bridge Filter Applications Parameters
Parameter
Valid Values
Default Value
Permit
Y/ N
N
Fi lter "n"
0–65535
0
Nod e Name=n ode_xyz
Bridge Filter Ap plications
*
Bridge Port N umber
2
*
Filter Type
5 MA C
*
Direction
I–I nbou nd
A Permit
Y
B Filter App lication 1
0
C Filter App lication 2
0
D Filter App lication 3
0
E Filter App lication 4
0
F Filter App lication 5
0
G Filter App lication 6
0
H Filter App lication 7
0
I
Filter App lication 8
0
J
Filter App lication 9
0
K Filter App lication 10
0
Option: