Cabletron Systems FRM User Manual - page 62
5-4
Frame Relay Module 4. 0 User G uide, Rev 01
Figure 5-3 LAN Card Configuration Screen
[A],[C],[B]
from Main Menu
Press
[F7]
after making any changes, to send the configuration to the LAN interface.
If the node is connected to a LAN after this record is created, or if the node
becomes disconnected from the LAN, the LAN connection must be ini-
tialized/re-initialized by opening the LAN Card Configuration record, then
pressing
[F7]
to send the configuration to the LAN interface. (Be sure the
FRM is connected to the LAN before performing this operation.)
LAN Card Parameters
Locally Admin. MAC Addr
is a MAC address that will override the universally administered MAC address. If all
zeros are specified, the universal address will be used. Under most circumstances, this
parameter should be left at the default setting.
Table 5-2 LAN Card Parameters
Parameter
Valid Values
Default Value
Locally Adm in. MAC Addr
000000000000–7ffffffffffff
000000000000
Nod e Name=nod exyz
LAN C ard Con figu ration
*
I nterface N umber: 0
*
Typ e
Ethern et
B
Locally Ad min MAC Ad dr
400000000001
Option: