Cabletron Systems FRM User Manual - page 235
Configuring Bridging
15-3
Configuring Default Node-Wide Bridging Parameters
If one or more Bridge ports (interfaces) will be established in the local node, certain
parameters must be configured to define bridge operation. Press
[B]
at the Configure
IP/LLC2/BRIDGE/IPX Default Parameters Menu (or
[A], [A], [E], [B]
from the Main
Menu). When prompted, enter:
●
Virtual LAN ID
– if also configuring LLC2 or Bridging in the node, enter a value
of
0–fff
(hex). Otherwise, press
[Enter]
(accepting the default of
000
).
LAN IDs can also be configured in LLC2 Interface/Bridge
Port records (later in this chapter). Each LAN ID must be
unique within the network on which this node will operate.
●
Any remaining requested information, referring to
Table 15-1
.
Figure 15-1 Bridge Node Defaults Configuration Screen
[A],[A], [E],[B]
from Main Menu
Nod e Name=nod e_xyz
Con figu re Bridge/LLC2 N ode D efau lts
A V irtual LAN ID
000
B Bridge En abled
N
C Bridge Hello Time
2
D Bridge Max A ge
20
E Bridge Forward D elay
15
F Bridge A gin g Timer (secon ds)
300
G Bridge Priority
0
H Max Size Bridge Forwarding Tab le
65535
I
I P Brid gin g Enab led
N
J
I PX Bridging En abled
N
K S RB ID
0
L D efau lt Ethernet Frame Type
Type I I
Option::