Cabletron Systems FRM User Manual - page 222
14-8
Frame Relay Module 4. 0 User G uide, Rev 01
Configuring IPX Filter Applications
IPX Filter Applications determine how filters will be used at the interface. To review
existing applications, press
[C]
at the Configure Filter Definitions and Applications
Menu (or
[A], [A], [E], [F], [C]
from the
Main Menu). To configure an application, press
[D]
at the Configure Filter Definitions and Applications Menu. When prompted, enter:
●
Interface number:
0–63
. (The default is
0
.) This identifies the virtual interface.
●
Filter Category
:
0
= RIP,
1
= SAP,
2
= Packet,
3
= RIP Router. (The default is
0
.)
●
Direction
:
i
(inbound) or
o
(outbound). (The default is
o
.)
●
Any other requested information, referring to
Table 14-6
.
Figure 14-3 Typical IPX Filter Applications Record
[A], [A],[E], [F],[D]
from Main Menu
Up to 100 filters can be configured, displayed over 9 "pages" (screens).
When finished configuring filter definitions and applications, perform an on-line
update to make the changes effective immediately. Press
[E]
at the Filter Definitions
and Applications Configuration Menu. The changes will be sent to the software
running on the RLP(s).
IPX Filter A pplications
*
Interface N umber
2
*
Filter C ategory
0 RIP
*
Direction
I–I nbou nd
A
Permit
Y
B
Filter A pplication 1
0
C
Filter A pplication 2
0
D
Filter A pplication 3
0
E
Filter A pplication 4
0
F
Filter A pplication 5
0
G Filter A pplication 6
0
H Filter A pplication 7
0
I
Filter A pplication 8
0
J
Filter A pplication 9
0
K Filter A pplication 10
0
2
Page 2
Option: