Cabletron Systems FRM User Manual - page 251
Configuring SNMP
16-3
Configuring a Community Table
Up to 16 SNMP manager devices can gain access to the agent running in an FRM.
Each manager device has an associated "community" name, configured at that device,
that identifies it to agents and other managers. That name is included in each SNMP
request that comes into a node. The request will be accepted only if the community
name is in the Community Table.
Press
[B]
at the SNMP Configuration Menu
to display the table.
Figure 16-2 SNMP Community Table Menu
[A],[A],[D], [B]
from Main Menu
To configure an entry, press the corresponding "
Seq
" (sequence) number. To delete an
entry, select it, then press
[D]
(and
[Y]
when asked to confirm). All entries below a
deleted one will move up one in the list.
Nod e Name=n ode_xyz
Commun ity Table
A Seq
B Name
CA ccessD
Del
1
name1
Read_w rite
2
name2
Read_w rite
3
name3
Read_w rite
4
name4
Read_w rite
5
name5
Read_w rite
6
name6
Read_w rite
7
name7
Read_w rite
8
name8
Read_w rite
9
name9
Read_w rite
10
name10
Read_w rite
11
name11
Read_w rite
12
name12
Read_w rite
13
name13
Read_w rite
14
name14
Read_w rite
15
name15
Read_w rite
16
name16
Read_w rite
Option::