Cabletron Systems FRM User Manual - Configuring Subscriber Ids
9-14
Frame Relay Module 4. 0 User G uide, Rev 01
Configuring Subscriber IDs
This operation configures the called and calling addresses that will be used for con-
necting to an LLC2 host, or in X.25 call setup if SNA is being transported over a
logical X.25 port. To complete the connection, the software must recognize where the
call is coming from (calling address) and where it is going (called address).
To display a list of current Subscriber IDs (addresses), press
[A]
at the Connections and
Routing Paths Menu (or
[A], [D], [A]
from the Main Menu).
To add or change a Subscriber ID, press
[B]
at the Connections and Routing Paths
Menu. When prompted, enter a Subscriber ID of up to 15 digits. (ID conventions are
described on
page 8-22
.)
Figure 9-4 Typical SVC Subscriber Screen
[A],[D],[B]
from Main Menu
Pressing
[G]
will display routing paths, which link the subscriber with one or more
ports. Pressing
[H]
will display the addresses used for call redirection. (These
addresses are valid only if
Y
is specified for one or more of items C, D, and E on the
first screen.) Parameters for all three screens are described following
Table 9-3
.
Nod e Name=nod exyz
SV C Sub scriber Main ten ance
*
Sub scriber ID
0100012345
A
Sub scriber Name
su b1
B
Routing Algorithm
0, Rou nd Robin
C
Systematic Redirection
N
D
Redirect on Busy
N
E
Redirect on Ou t of Order
N
F
Conn ection Priority
0
G Routing Path s
H Redirection Ad dres ses
Option: