Cabletron Systems FRM User Manual - page 242
15-10
Frame Relay Module 4. 0 User G uide, Rev 01
Filter Name
helps the user identify the filter. The name is not used by the software.
Protocol ID Value
is the IEEE 802 value of the protocol (SNAP or Type II) to which the filter will apply.
Filter Name
helps the user identify the filter. The name is not used by the software.
Source NetBIOS Name
should be obtained from a system administrator.
Destination NetBIOS Name
should be obtained from a system administrator.
Configuring Bridge Filter Applications
Bridge Filter Applications determine how filters will be used at the interface. To
review existing applications, press
[H]
at the Filter Definitions and Applications Con-
figuration Menu (or
[A], [A], [E], [F], [H]
from the Main Menu). To configure an appli-
cation, press
[I]
at the Filter Definitions and Applications Configuration Menu. When
prompted, enter:
●
Bridge Port Number
:
0–95
. (The default is
0
.) (This number simply identifies the
interface.)
●
Filter Type
:
4
= Generic
5
= MAC (Default)
6
= LLC2 SAP
7
= Protocol
8
= Bridged native NetBIOS.
Table 15-5 Bridge Protocol Filter Parameters
Parameter
Valid Values
Default Value
Filter Name
1–31 characters
none
Protocol ID Value
0–ffff (2 bytes)
0000
Protocol ID Mask
0–ffff (2 bytes)
0000
Table 15-6 Bridge NetBIOS Filter Parameters
Parameter
Valid Values
Default Value
Filter Name
1–31 characters
none
Source NetBIOS Name
1–36 characters
none
Desti nation NetBIOS Name
1–36 characters
none