Cabletron Systems FRM User Manual - page 128
9-4
Frame Relay Module 4. 0 User G uide, Rev 01
Figure 9-2 SNA Port Screen 1
[A],[C],[A]
from Main Menu
After making any changes, be sure to press
[F7]
to update the
system memory. Otherwise, the changes will not take effect until
the next re-boot of the FRM.
After configuring the above screen, press
[O]
to display a second screen. (The param-
eters for both screens are listed in
Table 9-1
on page 9-6.)
You must also define the PUs (physical units) that will communicate via the SNA port.
Once the
Additional SNA Port Parameters
are configured, press
[F3]
to return to Figure
9-2, then press
[P]
,
[A]
to display a list of configured PUs, or
[P]
,
[B]
to configure a PU.
If configuring a PU, enter (when prompted) an
SDLC PU Station Address
:
01–FE
(hex).
This address identifies the PU you are configuring, and must match the
ADDR
parameter set in the macro PU in the VTAM configuration. (The station address is
usually set to
C1
for point-to-point SDLC lines, and in series
C1, C2, C3
, etc. for mul-
tidrop lines.)
After entering a station address, a screen similar to the following will be displayed.
Node Name=nod exyz
SN A Port Parameters
*
R LP 0
Port 5
Lin k State
Lin kup
*
I /O: V .35
Databas e
System Memory
A
Port Type
SNA
SNA
B
N ame
sna1
sna1
C
Phys ical Port In terface
V.35
V.35
D
Blocked Port Flag
N
N
E
Line S peed
64k bps
64k b ps
F
N o Data Poll Period (ms)
40
40
G N o Resp Poll Period (ms )
2000
2000
H Maximum R etrans mis sions
5
5
I
Outs tanding Frames
7
7
J
Generate C lock
Y
Y
K R cv Clock (TT) from DTE
N
N
L
S NA
Type 2
h pad
2
hp ad
M N RZ
Y Y
N
Packet Size
1024
1024
O A dditional SN A Port Parameters
P
S DLC PU Operation s
Option: