Cabletron Systems FRM User Manual - page 206
13-8
Frame Relay Module 4. 0 User G uide, Rev 01
If a Source IP Address is specified/changed, the Network
Mask will automatically change to a default value appro-
priate for the new address. For this reason, configure the
Source IP Address first, then the Network Mask.
1
Y
for new interfaces,
N
for interfaces already configured when the current release of
FRM software is installed.
2
255.255.255.255
is valid only on a point-to-point interface.
3
See the caution following these footnotes. The default value of
Network Mask
will be
configured automatically, to reflect the appropriate address class, after the
Source IP
Address
is specified..
If the interface is configured as unnumbered (and, therefore, no
Sour ce IP Address
is configured), the default value of
Netw or k Mask
will be taken from
the numbered interface that is assigned.
If a
Source IP Address
is specified/changed, the
Network Mask
will automatically change to a default value appropriate
for the new address. For this reason, configure the
Source
IP Address
first, then the
Network Mask
.
4
These addresses must also be configured in Subscriber ID records (see
page 8-21
), and
cannot contain wildcards. In the record for the Source Subscriber, do not configure any
Routing Path. In the record for the Destination Subscriber, configure
1st Routing Path
as the node, RLP, and X.25 port that will be used for the physical interface. (That RLP
does not need to be the same one that has IP installed.)
Table 13-3 X.25 IP Interface Parameters
Parameter
Valid Values
Default Value
Maximum Transmission Unit
1–4096
1500
Routi ng Metri c Count
0–255
0
ICMP Redi rects
Y/N
Y
RIP Support
0
(Enabled),
1
(Rcv only),
2
(Disabled)
0
(Enabled)
RIP Flash Updates
(sec)
5–300
10
RIP Ful l Updates
(sec)
10–300
30
Pr iority
0–9
5
Bandwi dth Allocation Group
1–16
1
Interface Type
X.25
n/a
Desti nation IP Address
1. 0.0.0–223.255.255.255
none
Unnumbered Interface
Y/N
see note
1
Source I P Address
1. 0.0.0–223.255.255.255
none
Network Mask
255.0.0.0–255.255.255.255
2
255.0.0.0
3
Source Subscr iber
valid subscriber address
4
none
Desti nation Subscriber
valid subscriber address
4
none
SVC Retry Ti mer
(sec)
5–60
20
SVC Idle Timer
(min)
0–5
1
Max VCs to Establi sh
1–8
1
PVC Connection
Y/N
N