Cabletron Systems FRM User Manual - Displaying Sdlc Pu Status
19-20
Frame Relay Module 4. 0 User G uide, Rev 01
Displaying SDLC PU Status
To display the status of all PUs on an SNA port, press
[C]
at the Protocol Status Dis-
plays Menu. When prompted, enter the RLP and port numbers.
Figure 19-10 SDLC PU Status Display
[C], [F],[C]
from Main Menu
Information in this Display:
●
Station Address
– (specified when configuring the SNA port) identifies the PU,
and must match the
ADDR
parameter set in the macro PU in the VTAM config-
uration. (The station address is usually set to
C1
for point-to-point SDLC lines,
and in series
C1, C2, C3
, etc. for multidrop lines.)
●
Name
– PU name configured in the PU parameters in the SNA Port record.
●
State
– will be one of these:
◆
Active
◆
Inactive
◆
Never_Activated
◆
Pending_Contact
– waiting for Normal Response Mode
◆
Pending_Discontact
– waiting for Normal Disconnect Mode
◆
Inoperational
– due to failure of a higher resource (e.g., port)
N ode N ame= node_xyz
SDLC PU Status Disp lay for RLP: 0
Port: 2
Station A ddress
N ame
State
D1
Pud 1
Never_Activated
D2
Pud 2
Active