Cabletron Systems FRM User Manual - Rlp And Protocols
5-2
Frame Relay Module 4. 0 User G uide, Rev 01
RLP and Protocols
The RLP file contains the information shown in
Figure 5-2
for each RLP. To access
the RLP screens, press
[A]
, then
[B]
from the Main Menu.
To display a table of memory usage, press
[C]
at the RLP Configuration Menu. This
information, in conjuction with information in the release notes, can help in planning
the number of protocols to run.
To configure a protocol, press
[B]
at the RLP Configuration Menu. When prompted
for an
RLP number
(see
Figure 5-1
), type a number:
0–2
, then press
[Enter]
.
Figure 5-2 RLP Configuration Menu
[A],[B],[B]
from Main Menu
To add or remove a protocol, press the letter corresponding to the protocol number.
The protocol in the
Configured
column will change to the next valid one.
(See
Table 5-1
.)
After all desired changes have been made, press
[F3]
to save the changes, then reboot
the FRM as follows:
Rebooting will clear all connections on this device. However, the
device must be rebooted to implement the change.
1. Press
[F10]
.
2. When asked:
Reboot the Node?
, press
[Y]
.
3. Type
restart [Enter]
.
Node N ame= nodexyz
RLP C onfiguration
* RLP: 0
* Statu s:
In stalled
* Memory Configuration:
8 Meg
*
RLP Typ e:
R LP
*
Line In terface Card 1:
V.35
*
Line In terface Card 2:
V.35
Con figu red
Load ed
F Protocol 1:
X.25
X .25
G Protocol 2:
FRL
FRL
H Protocol 3:
As ync
A sync
I
Protocol 4:
SD LC
S DLC
J
Protocol 5:
IP
I P
K Protocol 6:
Non e
L Protocol 7:
Non e
M Protocol 8:
Non e
N Protocol 9:
Non e
Op tion :