Cabletron Systems FRM User Manual - page 120
8-32
Frame Relay Module 4. 0 User G uide, Rev 01
received. The packet matches Template ID
3110*U??
; therefore, a translation
occurs as follows:
◆
User data
99
from the packet is appended to the called address
311012345678
.
The translated called address is
31101234567899
.
Testing a Translation Template
Press
[C]
at the X.25 Address Translation Templates Menu (
[A], [C], [C], [C]
from the
Main Menu) to test a translation template you have created.
When prompted, enter:
●
RLP:
0–2
. (The default is
0
.)
●
Port
:
0–7
. (The default is
0
.)
●
Direction
:
I
(incoming) or
O
(outgoing). (The default is
I
.)
●
Called address
to be translated.
●
Calling address
to be translated.
●
Facility length + facility + user data
. (The user data includes four bytes for pro-
tocol ID, which must be entered as a hex string.) To specify only user data, at
the above prompt enter
00
for a facility length, nothing for a facility, then the
desired user data, including the 4-byte protocol ID.
After you enter this information, the FRM creates a test packet and sends it through
the translation process, and displays the results, as shown in the following example.
Figure 8-11 Address Translation Test Screen
[A],[C],[C],[C]
from Main Menu
N ode Name=n odexyz
Packet Trans lation Tes t
Port:0
Direction :Incoming
Original Packet:
10010B7712345673333333000100000035353535
C alled Add ress :
1234567
C alling A ddress: 3333333
U ser Data Protocol ID : 01000000
U ser Data:
55555
Facilities:
Trans lation Template:
Template I D:
1234C *U*
C alled Add ress :
L8401X 7
C alling A ddress: P
U ser Data Protocol ID : P
U ser Data:
P
Facilities:
P
Trans lated Pack et:
10010B74840133333330000100000035353535
C alled Add ress :
8401
C alling A ddress: 3333333
U ser Data Protocol ID : 01000000
U ser Data:
55555
Facilities:
S trike any k ey to continu e