3Com NBX 100 Administrator's Manual - page 121
Configuring the Attendant Console
121
Removing an
Attendant Console
To remove an Attendant Console from the system:
1 Click Telephone Configuration > Attendant Console.
2 Select the Attendant Console, or Attendant Consoles, that you want to
delete and click Remove Selected. To select all Attendant Consoles,
enable the Select check box.
3 Click OK in the dialog box to confirm.
Configuring
Attendant Console
Buttons
This section describes how to configure the buttons on the Attendant
Console. The Attendant Console buttons include:
■
50 Access buttons. You can assign each button two settings.
■
A Shift button. This button switches between the two settings
allowed for each Access button.
■
Four Feature buttons.
Configuring Feature Buttons
To map the Attendant Console Feature Buttons:
1 Click Telephone Configuration > Attendant Console.
2 Click the Attendant Console extension for which you want to map
Feature Buttons.
3 Click the Feature Mapping tab.
4 Use the drop down list next to each button to select the feature you want
to assign to the button.
For a description of each function you can assign to a button, see the
online Help.
5 Click Apply to implement the new mappings.
Mapping the Attendant Console Access Buttons
To map the Attendant Console Access buttons:
1 Click Telephone Configuration > Attendant Console.
2 Click the Attendant Console extension you want.
3 Click the Button Mapping tab.
4 To map the buttons that you want, follow these steps:
a Select the appropriate column of buttons. Click 1-50 to select columns
A through E, or 51 through 100 to select columns F through J. (This