3Com NBX 100 Administrator's Manual - page 224
224
C
HAPTER
9: NBX M
ESSAGING
For information about how to configure the dial plan to use VPIM, see
“Dial Plan Configurations and VPIM”
on
page 302
.
Control Parameters
To configure VPIM control parameters, click NBX Messaging > VPIM.
Table 45
explains the VPIM control parameter fields and their purpose.
Operations
Management
To manage the queue of outgoing voice mail messages, click NBX
Messaging > VPIM and then click the Operations Management tab.
Table 46
describes the fields in this window.
Some commands require that you start or stop operations. For example,
to remove a message from the queue, first stop operations. Similarly,
Table 45 VPIM Tab Fields
Field
Purpose
Maximum message size (Kbs)
Controls the size of incoming messages from other
sites. If a message is larger than the specified
value, the system rejects it. The default value
represents a voice mail message approximately 4
to 5 minutes in length.
Default: 3000 KB
Minimum: 500 KB
Maximum: 5000 KB
Time between send attempts
(Minutes)
For outgoing messages, the system might not be
able to contact the target system on the first
attempt. If so, the system attempts to contact the
target system later. To change the time between
attempts to send a voice mail message, change
this number.
Default: 15 minutes
Minimum: 1 minute
Maximum: 60 minutes
Maximum number of send
attempts
Specifies the number of times the system attempts
to connect to the target system.
After the specified number of send attempts, the
system returns the voice mail message to the
sender’s voice mail box with an indication that the
message could not be sent.
Default: 4 attempts
Minimum: 1 attempt
Maximum: 10 attempts
Maximum time before message
expires (Minutes)
Default: 60 minutes