3Com NBX 100 Administrator's Manual - page 448
448
A
PPENDIX
A: I
NTEGRATING
T
HIRD
-P
ARTY
M
ESSAGING
Configuring the
System
To activate third-party messaging on the system use the NBX NetSet utility
to perform the tasks described in this section. All NetSet procedures
require an administrator login.
1 Add the Third-party Messaging and Media Driver licenses to your system:
a Click Licensing and Upgrades > Licenses > Add License.
b In the License Key field, enter the license key provided by your 3Com
Voice-Authorized Partner.
c Click Apply.
d Add any additional licenses. When you are finished adding licenses,
click OK.
e Reboot the system.
3Com strongly recommends that you back up your licenses each time you
make a license change.
2 Verify that Auto Discover Telephones is enabled:
a Click System-Wide Settings > Auto Discovery.
b Verify that Auto Discover Telephones is enabled.
c Click Apply.
3 Verify that NBX Messaging is disabled:
a Click System-Wide Settings > Enable Features System-Wide.
b Verify that NBX Messaging is disabled.
c Click Apply.
4 Create a Hunt Group for the third-party messaging system:
a Select Call Distribution Groups > Hunt Groups > Add.
b Set the following parameters:
■
Name — UM Hunt Group (or some similar name).
■
Type — HuntGroup - Circular.
3Com recommends that you use a circular hunt group.
■
Extension — Enter the appropriate extension for your hunt group.
■
Password — Set the password for this hunt group.
■
Logout if no answer — Verify that this check box is empty.