3Com NBX 100 Administrator's Manual - page 318
318
C
HAPTER
11: D
IAL
P
LAN
You define start and end times for system modes through the NBX NetSet
utility. Click System-Wide Settings > Business Hours. Enter the times that
you want and click OK.
Example: If you define business hours from 8:00 to 17:00 on Mondays,
Wednesdays and Fridays, and from 9:00 to 18:00 Tuesdays and
Thursdays, then a timed route entry both szStartTime and szEndTime set
to “open” applies differently on Monday, Wednesday, and Friday than on
Tuesday and Thursday.
You set the beginning and ending times for open, lunch, and other using
the NBX NetSet utility. Click System-Wide Settings > Business Hours. The
system treats all times not included these three categories as closed.
szEndTime
— End time in 24-hour format, for example, “18:30” for
6:30 p.m. You can use either 00:000 or 24:00 to indicate midnight. If you
use a system mode (open, lunch, or other) for szStartTime, you must use
the same system mode for szEndTime.
szDaysOfWeek
— A seven character mask in which each character
position represents one day of the week, beginning with Sunday as the
first character and ending with Saturday as the last character. The system
excludes any day if a dot “.” character appears in that day's position. (As
a convention, you place the first letter of each day in the appropriate
character position to indicate that the day is included, but you can use
any letter you want; the presence of a dot “.” in a given position excludes
the day of the week and the presence of any other character in that
position selects that day.
You use the szDaysOfWeek parameter to specify when this timed route is
active. You can specify that the timed route entry apply to all days of the
week. If you specify the start and end times for open mode differently on
some days of the week than for other days, one timed route entry can
operate differently depending on the day.
Example: The system interprets “SMT.T.S” (or “XXX.X.X”) as “all days
except Wednesday and Friday.” The “dot” characters in positions four
and six exclude the fourth and sixth days of the week (Wednesday and
Friday).
nDestinationRouteId
— The Id of the destination route to use if this entry’s
time of day and day of week criteria are met.