3Com NBX 100 Administrator's Manual - page 158
158
C
HAPTER
8: PSTN G
ATEWAY
C
ONFIGURATION
If you remove a line card from the system, the port information remains in
the system database. The extension numbers assigned to the four ports
do not become available for reuse unless you use the NBX NetSet utility
to remove the line card from the configuration database.
This section describes these topics:
■
Configuring a Line Card Port
■
Modifying a Line Card Port
■
Removing a Line Card Port
■
Verifying Line Card Port Status
■
Rebooting a Line Card Port
■
Advanced Settings
Configuring a
Line Card Port
When you configure a line card port, you can assign it as a member of a
line pool.
You can configure a line card port automatically (recommended) or
manually.
Verify that you have chosen a 3-digit or 4-digit dial plan before you begin
to configure line card ports. See
Chapter 11
for information about how
to configure the dial plan.
Configuring a Line Card Port Automatically
To configure a line card port automatically:
1 Login to the NBX NetSet utility using the administrator login ID and
password.
1 Click System-Wide Settings > Auto Discovery.
2 Enable the
Auto Discover Other Devices
(including ATA, Digital Line Cards
& Analog Line Cards) check box.
3 Click
Apply
.
Configuring a Line Card Port Manually
Most organizations use Auto Discovery to configure line card ports
automatically. However, you can configure a line card port manually and
select all settings.