3Com NBX 100 Administrator's Manual - page 380
380
C
HAPTER
16: N
ETWORK
M
ANAGEMENT
Standard SNMPv3
MIBs
The system supports the following standard SNMPv3 MIBs. Where
applicable, you can configure SNMPv2 through these MIBs as well.
■
SNMP-FRAMEWORK-MIB
Supported: The standard Framework and Conformance MIB
■
SNMP-MPD-MIB
Supported: The standard Message Processing and Dispatch MIB and
Conformance MIB
■
SNMP-TARGET-MIB and SNMP-NOTIFICATION-MIB
Supported: The standard Target, Notification, and Conformance MIBs
Filter-related tables might impose a maximum limit of zero entries,
effectively disabling this feature. The system supports up to eight
notification targets entries.
■
SNMP-USER-BASED-SM-MIB
Supported: The standard User-based Security Model and
Conformance MIB
The default table is initialized according to the Security Posture of
minimum-secure. User table entries are instantiated and keys are
generated based on each system login user name and password in
force when the SNMPv3 software version is first upgraded.
■
SNMP-VIEW-BASED-ACM-MIB
Supported: The standard View-based Access Control Module and
Conformance MIB
This MIB is read-only and has permanent entries. The default security
configuration is initial-minimum-security-configuration.
The vacmSecurityToGroupTable contains the current mapping of
usernames to groups. One row exists for each username configured.
The vacmAccessTable contains four permanent entries (one for each
access level) and one additional entry for security access.
■
SNMP-COMMUNITY-MIB
The standard Community and Conformance MIB is not required.
Other IEEE/RFC MIBs
The NBX Enterprise MIB, which is a private MIB, provides information
about the status of the system. See
Appendix G
on
page 373
for more
information.