3Com NBX 100 Administrator's Manual - page 315
Dial Plan Configuration File Commands
315
Table Create
Syntax
Table Create nDialPlanTableId szDescription
Description
Creates a dial plan table to control the routing of calls
placed by devices. Dial plan tables apply to internal devices such as
telephones, incoming calls from outside the system, and Least Cost
Routes. If the dial plan table already exists, this command removes all
entries from the table, and fills the table with the new information.
Arguments
nDialPlanTableId
— An integer in the range 1 through 32768. The default
dial plan tables use ID numbers 1 through 3:
1 — Internal dial plan table
2 — Incoming dial plan table
3 — Least Cost Routing table
szDescription
— The description or name of the dial plan table. the NBX
NetSet utility uses this name to refer to the table.
Example: This example command creates dial plan table 1 and names it
“Internal 4 Digit Extensions.”
Table Create 1
Internal 4 Digit Extensions
TableEntry Create
Syntax
TableEntry Create nDialPlanTableId nEntryId szDigits
nMinDigits nMaxDigits szCallClass nPriority nRouteId
Description
Creates an entry in a dial plan table that specifies a string
of digits that are compared to the dialed digits. If the dial plan table entry
already exists, this command overwrites it with the new information.
Dial plan table entries make Class of Service and call routing decisions
based on the correspondence of dialed digits and table entry digits.
Arguments
nDialPlanTableId
— An integer in the range 1 through 32768. The system
reserves three ID numbers:
1 — Internal dial plan table
2 — Incoming dial plan table