Intergraph TD-300 Maintenance Manual - Advanced Setup
88 Chapter 6 - Using AMIBIOS Setup
Floppy A, Floppy B
-- The Floppy A and Floppy B icons allow you to
specify the type of floppy disk drive installed in the workstation.
➤
To change the floppy drive parameters:
Note:
The floppy disk drive A parameter is preset to 1.44 MB 3.5-inch.
Do not change the parameter unless you replace floppy drive A with
a different capacity disk drive.
Note:
The floppy disk drive B parameter is preset to Not Installed, unless
an optional drive has been installed before to shipment. Do not
change the parameter unless you install an optional floppy disk
drive.
1.
Select the Floppy A or Floppy B icon.
2.
Press the up and down arrow keys or click in a box to select the
correct parameter for the floppy disk drive.
3.
Press
ENTER
to accept the change, or click on the close icon in the
upper left corner of the floppy disk drive configuration menu.
Master Disk, Slave Disk
-- The Master Disk and Slave Disk icons
represent parameters for Integrated Device Electronic (IDE) drives, which
are not used in the deskside workstations. Since the workstation uses high
performance SCSI-2 hard disk drives, the Master Disk and Slave Disk
parameters should not be changed. Both entries are set to Not Installed.
Advanced Setup
The Advanced icon in the AMIBIOS Main Menu allows you to change
details of the system’s operation. Each parameter included in the Advanced
Setup menu is described below.
Note:
To change a parameter’s value, move the pointer to a parameter and
click the mouse button. An Options menu displays allowing you to
select one of the choices.