Intergraph TD-300 Maintenance Manual - page 85
Chapter 5 - Upgrading the System 71
3.
Remove the SIMMs from the static bag and install them in this order:
♦
If the total number of installed SIMMs will be two, install the
SIMMs in the Bank 0 sockets.
♦
If the total number of installed SIMMs will be four, install the
SIMMs in the Bank 1 sockets first, then in the Bank 0 sockets.
♦
If the total number of installed SIMMs will be eight, install the
first SIMM in Bank 3 socket J58. Install the remaining SIMMs in
the next empty socket until Bank 0 socket J51 is the last socket
populated.
4.
Position the SIMM in the next available socket so that the notch faces
the back of the base unit.
5.
Insert the SIMM at a 60 degree angle, pressing it firmly into the
socket.
Bank 2
Bank 3 (socket J58)
Bank 0
(socket J51)
Bank 1
Bank 1
Bank 3
Bank 2
Bank 0