Intergraph TD-300 Maintenance Manual - page 53
Other manuals for TD-300:
Maintenance Manual
of
138
Chapter 3- Opening and Closing the Base Unit 39
3.
If ISA option boards are installed, disconnect the SCSI cable and
power cables from the top of the riser card, and remove the ISA I/O
lock bracket.
4.
Remove the screw on the pivoting ISA board guide as shown in the
following figure.
5.
Remove the installed ISA boards. Note the position of each ISA
board, for you must replace the boards in the same slots from which
you remove them.
6.
Remove the four screws for the option board bracket as shown in the
following figure. Slide the option board bracket to the back of the
base unit and remove.
ISA I/O Lock
Bracket
Power Cable
Connector
SCSI Cable
Connector