Intergraph TD-300 Maintenance Manual - page 33
Chapter 2 -- Configuring the System 19
➤
To change the monitor refresh rate:
1.
Open MGA Monitor in the Windows NT Control Panel. The MGA
Monitor Selection dialog displays.
2.
Select the appropriate monitor from the Monitor List. If your
system’s monitor is not listed, select one with a maximum refresh rate
matching the one your system uses. An MGA.INF file will be created
in the SystemRoot\SYSTEM32 directory.
Note:
In a multiple G95 configuration, the MGA.INF setting affects all
monitors. Intergraph recommends that the monitor you select in
MGA Monitor be compatible with the least-capable monitor
used by your system.
➤
To test the new monitor selection:
1.
Open Display in the Windows NT Control Panel.
2.
Select the resolution and pixel depth you want to test.
3.
Select Test. If the display is satisfactory, go to step 6. If not,
continue.
4.
If your monitor does not display a stable test screen, the parameters
set by the MGA.INF file are not suitable for your monitor. Select
Cancel to close Display.
5.
Run MGA Monitor again to select a different monitor.