Intergraph TD-300 Maintenance Manual - page 133
Appendix A - Installing System Software 119
4.
You are presented with two screens of information. After you finish
reading each of them, press any key to return to the Main Menu.
5.
If you are finished installing the MS-DOS CAD drivers, select Exit or
press
ESC
to quit the installation program. Otherwise, continue to the
next procedure.
Note:
Ensure that you have installed the Windows 95 drivers and selected
a monitor with the Monitor Selection program before using the G95
graphics controller. Refer to Chapter 2, “Configuring the System,”
for more information.
➤
To install the AutoCAD/DynaView driver:
1.
At the Main Menu, select AutoCAD/3D Studio DynaView Driver.
2.
Press
ENTER
to accept the default directory path. The display driver
files are copied to the system disk.
3.
Select the version of AutoCAD that you use.
4.
Type the directory path for your AutoCAD drivers if different from
the default directory path.
5.
Press
ENTER
to prepare AutoCAD for automatic setup. Press
ENTER
again to accept the default boot drive C.
6.
Press any key to return to the Main Menu.
7.
If you are finished installing the MS-DOS CAD drivers, select Exit or
press
ESC
to quit the installation program. Otherwise, continue to the
next procedure.
➤
To install the Microstation 5.0 driver:
Note:
This driver does not support Microstation 4.0.
1.
At the Main Menu, select Microstation Drivers.
2.
Press
ENTER
to accept the default directory path. The display driver
files are copied to the system disk.