Intergraph TD-300 Maintenance Manual - Driver.
108 Appendix A -- Installing System Software
q
Configure a local user account and password.
q
Log on to Windows NT Workstation.
q
Install and configure the G95 video display
driver.
Install and configure the G95 video display driver.
➤
To install the G95 video display driver:
1.
Open Display in the Windows NT Control Panel. The Display
Settings dialog displays.
2.
Select Change Display Type. The Display Type dialog displays.
3.
Select Change. The Select Device dialog displays.
4.
Select Other. The Install from Disk dialog displays.
5.
Insert the diskette containing the G95 display driver into the floppy
disk drive; then select OK.
6.
Select Install. When prompted, confirm the path to the directory in
which the driver will be installed.
Note:
If the video display driver was previously installed, the system
displays a dialog allowing you to choose the currently installed
driver or a new driver. Select New to install the video display
driver.
7.
When the MGA Monitor Selection dialog displays, you may select a
monitor as described in Chapter 2, “Configuring the System,” to
obtain higher screen refresh rates (greater than 60 Hz).
8.
Restart the system.
Refer to Chapter 2, “Configuring the System,” for information on
configuring the G95 video display driver. Refer the Windows NT