Intergraph TD-300 Maintenance Manual - page 129
Appendix A - Installing System Software 115
2.
If you are prompted to create a Startup Diskette, insert a blank diskette
into the floppy disk drive; then select OK. Setup copies the Startup
files to the diskette. When copying is complete, remove the diskette
and select OK to continue.
CAUTION
Once you have finished configuring the system, Intergraph recommends
that you update the Startup Diskette, and that you update it each time
you change your system’s configuration. You should also make and
keep a backup copy of the Startup Diskette.
3.
If you are prompted for the Windows 95 Setup Boot Diskette, select
OK. Change to drive A and select OK to continue.
➤
To configure the final installation:
1.
If there is a diskette in the floppy disk drive, remove it and select
Finish when prompted. The system restarts with the new Windows 95
setup.
2.
Select OK; then key in the names for your computer, your workgroup,
and the computer description when prompted. Select Close when
finished.
3.
If necessary, type a username and password for your Windows 95 user
account. If you do not want to create a user account at this time,
select Cancel.
4.
If your system is connected to a network, Setup may prompt you to
configure the network drivers and adapters. Respond to the prompts
as necessary.
5.
Select the appropriate time zone for your location; then select Close.
6.
If you are prompted to set up the Microsoft Exchange Inbox, select
Yes or No, as appropriate; then select Next. Follow the prompts, as
necessary.
7.
If you are prompted to set up your Microsoft Mail account, type the
path to your local Microsoft Mail post office. Type the name and the