Intergraph TD-300 Maintenance Manual - page 79
Chapter 4 - Maintaining the System 65
5.
Close the base unit.
Reprogramming the Flash EPROM
You can use the Flash Programming Utility (FPU) to reprogram the system
board flash EPROM with a new BIOS. When run, the FPU first looks on the
diskette in the floppy disk drive for a valid BIOS. Therefore it is best to save
the BIOS file and the FPU (available on the IBBS) to the System Utilities
(SYSUTIL) diskette.
Note:
The desktop workstations use the 741XX.ROM BIOS, where XX is
the version number.
The FPU is an MS-DOS utility that will not run in the Windows NT
environment. Use the SYSUTIL diskette delivered with your system to boot
the system into MS-DOS. The system must be set to boot from the floppy
disk drive (normally drive A) to use these utilities. If necessary, follow these
instructions to change the boot sequence.
➤
To change the workstation boot sequence:
1.
Restart the workstation. The American Megatrends banner screen
displays with the following message:
Press DEL if you want to run Setup
2.
Press
DELETE
. The AMIBIOS Setup Main Menu displays.
3.
Click on the Advanced icon. A list of parameters displays.
4.
Click on the System Boot Up Sequence parameter. The Options menu
displays with a choice of boot sequences. The default is C:, A:, which
designates the system hard disk drive (C:) is the initial device,
followed by the floppy disk drive (A:).
5.
Click on the A:, C: parameter to change the boot sequence; then press
ENTER
.
6.
Select the Exit and Save option to exit the AMIBIOS Setup program.