Intergraph TD-300 Maintenance Manual - Adding External Scsi Drives
74 Chapter 5 - Upgrading the System
6.
Connect the power cable and SCSI cable to the device.
7.
Close the base unit.
8.
Restart the system.
9.
If necessary, install the device’s drivers and configure the device
according to the vendor’s instructions.
Adding External SCSI Drives
You can add up to seven external SCSI devices to the deskside workstation.
The total length of the external SCSI cables must not exceed 19.2 feet.
Note:
The last device on the SCSI cable chain must supply active
termination. All other external devices must have SCSI termination
disabled or removed.
➤
To install an external SCSI device:
1.
Set device’s SCSI ID to an unused number and enable or disable the
device’s SCSI termination according to the note above and the
vendor’s instructions.
2.
Connect one end of the SCSI cable to the Fast SCSI-2 port on the back
of the base unit. If external devices are already installed, connect the
SCSI cable to the available SCSI port on the last device on the SCSI
cable chain.
3.
Connect the device to the other end of the SCSI cable.
4.
If necessary, install the device drivers and configure the device
according to the vendor’s instructions.