Intergraph TD-300 Maintenance Manual - Configuring The System
15
Chapter 2
Configuring the System
After setting up the system hardware and starting the system for the first
time, you can configure it for your use. Follow the instructions in this
chapter to configure the system when it is running Windows NT or Windows
95.
Note:
For instructions on configuring the system when it is running Solaris
2.5 for x86, refer to Intergraph’s Workstation Software
Configuration for Solaris 2.5 for x86.
Before You Begin
Before you begin configuring the system, get and record the following
TCP/IP networking information from your network administrator:
♦
Internet Protocol (IP) address for
your system:
♦
IP subnet mask for your system:
♦
IP domain name for your network:
♦
IP address for your network’s
default gateway:
♦
IP addresses for your network’s
Domain Name System (DNS)
servers, if any:
The Windows NT delivery media contain software and drivers for both
Reduced Instruction Set Computing (RISC)- and Intel-based systems. When
installing Windows NT distribution files, make sure to install them from the
\I386 directory (the Intel software directory) on the delivery media. For
example, if you are installing a device driver from the Windows NT CD-