Intergraph TD-300 Maintenance Manual - Adding Internal Scsi Devices

72          Chapter 5 - Upgrading the System

6.

Push on the top edge of the SIMM until it snaps into the metal clips.

The socket tabs must fit inside the mounting holes of the SIMM.

7.

Repeat steps 4 through 6 for each additional SIMM.

8.

Replace the graphics and PCI option boards and close the base unit.

9.

Restart the system.  The new memory is recognized automatically.

Adding Internal SCSI Devices

You can install internal SCSI devices such as hard disk drives, tape drives,

and CD-ROM drives in the auxiliary drive bays of the deskside workstation.

However, a bracket must be removed from the destination bay prior to

installation.  Also, if the device is more than one inch high, then the bay

underneath must be empty since the bays are designed to accommodate one-

inch high devices.

Note:

If purchasing SCSI devices from another vendor, carefully follow

the vendor’s instructions for setting the SCSI ID and disabling the

SCSI termination before installing the devices.

➤

 To install an internal device in the auxiliary drive bay:

1.

Select a bay to install the device and remove the blanking plate or

other device from the destination bay.

2.

Remove the screw that secures the disk drive slide bracket from the

destination bay, and remove the bracket.  Refer to the following

figure.