Intergraph TD-300 Maintenance Manual - page 51
Other manuals for TD-300:
Maintenance Manual
of
138
Chapter 3- Opening and Closing the Base Unit 37
➤
To remove the back cover:
1.
Remove the top cover and left side panel (as viewed from the front) as
described previously.
2.
Remove the seven screws from the back cover as shown in the
following figure. Pull on the side of the cover opposite the AC
receptacle to disengage it.
CAUTION
Do not remove the two screws at the top of the chassis. The power
supply will fall down, damaging the system hard disk drive.
3.
Do not disconnect the fan power cable unless instructed in the
maintenance procedures.
Screws
Screws
AC Receptacle