Intergraph TD-300 Maintenance Manual - page 37
Chapter 2 -- Configuring the System 23
Check for the following common video configuration problems and
solutions:
♦
A multi-sync monitor is selected, but a graphics display device with
different video timings (such as an Intergraph InterVue monitor) is
connected to the system. Select the appropriate monitor type as
described previously.
♦
The monitor selection set by the MGA Monitor application is
inappropriate for the multi-sync monitor attached to the system. Restart
the system in VGA mode, then select a new monitor as described
previously.
♦
A graphics resolution and color depth has been selected that exceeds
installed Windows RAM (WRAM) display memory. Restart the system
in VGA mode, then open Display in the Control Panel to re-install and
configure the G95 display driver as described in Appendix A, “Installing
System Software.”
Configuring TCP/IP Networking
Configure the TCP/IP networking software using the networking information
you recorded at the beginning of this chapter.
➤
To configure the TCP/IP networking software:
1.
Open Network in the Windows NT Control Panel. The Network
Settings dialog displays.
2.
Select Change next to the Computer Name field. The Computer Name
dialog displays.
3.
Type a name for the computer and select OK.
4.
If appropriate, select Change next to the Workgroup field. The
Domain/Workgroup Settings dialog displays.
5.
Type a new workgroup name and select OK.
6.
Select TCP/IP Protocol from the Installed Network Software list, and
then select Configure. The TCP/IP Configuration dialog displays.