Intergraph TD-300 Maintenance Manual - Replacing The Riser Card
54 Chapter 4 - Maintaining the System
➤
To install the new auxiliary hard disk drive:
1.
Disable SCSI termination and set the SCSI ID to the same SCSI ID as
the previous hard disk drive. Refer to the documentation delivered
with the hard disk drive for details.
2.
Secure the new disk drive to the bracket using the screws removed
previously.
3.
Slide the disk drive assembly into the chassis. Secure the disk drive to
the chassis with the screws removed previously.
4.
Attach the power cable and SCSI cable to the new disk drive. The
SCSI cable is keyed to ensure proper insertion. The red stripe (pin 1)
must be adjacent to the power connector.
5.
Close the base unit.
6.
Restart the workstation.
7.
Partition and format the auxiliary hard disk drive as described in the
operating system documentation.
Replacing the Riser Card
➤
To remove the riser card:
1.
Remove the option board bracket as described in Chapter 3.
2.
Disengage the riser card from the system board, and remove the card
from the base unit.
➤
To install the new riser card:
1.
Insert the riser card into the system board slot, pushing firmly over the
center of the PCI connectors.