Intergraph TD-300 Maintenance Manual - page 52
Other manuals for TD-300:
Maintenance Manual
of
138
38 Chapter 3 - Opening and Closing the Base Unit
➤
To remove the PCI access panel:
1.
Power off the base unit and remove the top cover and side panel. Lay
the base unit on the right side.
2.
Remove the two screws at the bottom of the unit and the screw behind
the PCI access panel as shown in the following figure.
3.
Slide the cover to the back of the base unit and remove it.
Removing the Option Board Bracket
You may have to remove the option board bracket to gain access to some
components in the base unit.
➤
To remove the option board bracket:
1.
Open the base unit as described previously.
2.
Remove the graphics boards and other installed PCI option boards.
PCI Access
Panel
Screws
Screw
(Behind Panel)