Intergraph TD-300 Maintenance Manual - page 80
66 Chapter 4 - Maintaining the System
7.
Insert an MS-DOS-bootable diskette into the floppy disk drive; then
restart the system.
For more information about the AMIBIOS Setup program, refer to Chapter
6, “Using AMIBIOS Setup.”
➤
To reprogram the flash EPROM:
1.
Connect to the Intergraph Bulletin Board Service (IBBS) via modem.
Refer to the Preface for instructions.
2.
From the TOP menu, go to Intergraph Product Centers, Systems and
Networking, File Libraries, and Delivered Drivers; then select the
appropriate operating system and hardware platform.
3.
Choose Find File to search for the FLASHPROG product; then
download FLASHPROG to your system.
4.
Several files are bundled in the FLASHPROG product, and must be
extracted using an unzip utility. The following files are extracted:
741XX.ROM
AUTOEXEC.BAT
FLASH.EXE
FLASH.TXT
MANIFEST.TXT
README.TXT
5.
Insert the SYSUTIL diskette into the floppy diskette slot of the combo
drive; then copy FLASH.EXE and 741XX.ROM to the diskette.
6.
Confirm that you want to replace the existing FLASH.EXE with the
new FLASH.EXE.
7.
Shut down and power off the system.
8.
Restart the system. When the MS-DOS Startup menu displays, select
the Intergraph Flash Utility. The following message displays.
Intergraph flash programming utility
Reading 741
XX
.ROM .