Intergraph TD-300 Maintenance Manual - Setting Up

Chapter 1 - Getting Started          3

Note:

If any of the base unit or monitor parts were not delivered, call the

Customer Response Center immediately at 1-800-633-7248.

Setting Up

Before you begin setting up your workstation, determine where you want to

place the system.  Keep these guidelines in mind:

♦ 

Place the base unit in an area where air can circulate freely around it.

The front and back of the base unit should have at least a three-inch

clearance.

♦ 

Do not expose the system to high levels of dust, smoke, or moisture.

♦ 

Place the system in an area where the temperature range stays between

10 

°

C and 26 

°

C (50 

°

F to 80 

°

F).  The optimum operating temperature is

21 

°

C (70 

°

F).

♦ 

Place the system in an area where the humidity stays between 20% and

80% (non-condensing).  The optimum operating humidity is 50% (non-

condensing).

➤

 To set up the workstation:

1.

Set the footstands on the bottom of the base unit.

2.

Connect the keyboard cable to the Keyboard port on the back of the

base unit.  Refer to the following figure.

3.

Connect the audio cables (bundled with the keyboard cable) to the

audio jacks.  The cable labeled Mic connects to the Microphone jack,

and the cable labeled Audio connects to the Line Out jack.  Refer to

the following figure.

4.

Connect the mouse cable to the Mouse port on the back of the base

unit.  Refer to the following figure.