Intergraph TD-300 Maintenance Manual - Other Hardware Errors
102 Chapter 7 - Troubleshooting
ERROR - Video displays during boot up, but not when operating
system initializes.
Reason
Solution
Selected resolution is not
supported by the monitor.
Select a supported resolution.
Refer to Chapter 2, “Configuring
the System,” and to the G95
README.TXT file for resolution
details.
Improper graphics driver is
installed.
Remove the driver and install a
valid driver. Refer to Appendix
A, “Installing System Software,”
for details.
Other Hardware Errors
ERROR - CD-ROM drive LED does not light.
Reason
Solution
CD-ROM drive power cable is not
attached.
Open the base unit and ensure
power cable is properly attached.
ERROR - Combo drive LEDs do not light.
Reason
Solution
Floppy disk drive power cable is
not attached.
Open the base unit and ensure
power cable is properly attached.
ERROR - Unsuccessful connection to serial device
Reason
Solution
Communication parameters
between workstation and serial
device do not match.
Change the parameters so the
workstation and serial device
match each other.