Intergraph TD-300 Maintenance Manual - page 76
Other manuals for TD-300:
Maintenance Manual
of
138
62 Chapter 4 - Maintaining the System
4.
Disconnect the inline connector for the power cable of the defective
fan as shown in the following figure.
5.
Using a No. 1 Phillips screwdriver, remove the fan from the assembly.
➤
To install the fan:
1.
Install the new fan to the assembly and connect the power cable.
2.
Install the fan assembly into the chassis and connect the fan power
cable to the system board.
3.
Replace the option board bracket.
4.
Close the base unit.
Replacing the System Hard Disk Drive Fan
➤
To remove the system hard disk drive fan:
1.
Power off the base unit. Remove the top cover, left side panel, and
back cover. The fan is secured to the back cover.
Inline Connectors