Intergraph TD-300 Maintenance Manual - page 113
Chapter 7 - Troubleshooting 99
program.
ERROR - CD-ROM drive is not recognized.
Reason
Solution
CD-ROM drive power cable not
attached.
Open the base unit and ensure
power cable is properly attached.
CD-ROM drive SCSI cable not
attached.
Open the base unit and ensure
SCSI cable is properly attached.
SCSI termination is not disabled.
Disable SCSI termination. Refer
to the CD-ROM drive vendor’s
documentation.
A SCSI address conflict exists
between the CD-ROM drive and
another SCSI device.
Set SCSI ID to an unused value.
Refer to the CD-ROM drive
vendor’s documentation.
ERROR - Combo drive not recognized.
Reason
Solution
BIOS is not configured properly.
Configure the Floppy A and B
parameters to required settings.
Combo drive power cable is not
attached.
Open the base unit and ensure
power cable is properly attached.
Floppy cable is not attached
properly.
Open the base unit and ensure
floppy cable is properly attached
at both ends. Refer to “Replacing
the Combo Drive” in Chapter 4.
ERROR - “Invalid configuration information for SLOT XX”
message displays.
Reason
Solution
System is not properly configured
to recognize the new ISA option
board.
Run the System Configuration
Utility and set the board to its
proper configuration according to
manufacturers instructions.
ERROR - Total amount of memory does not display.
Reason
Solution
Faulty SIMMs.
Determine faulty SIMMs by
swapping SIMMs until the faulty
one is found.
SIMMs not properly seated into
the socket.
Open the base unit and ensure
SIMMs are properly installed.