Server Technology switched pro2 User Manual - page 106
Switched PRO2 – User Guide
Using the Web Interface
•
106
To configure the SNTP server:
1. Local Date/Time: Displayed to show the local and current DST settings. To increment the settings (based
on updates to the options for DST Start/DST End and day/time), click the Update link.
2. The Primary/Secondary Host fields contact the SNTP server. The fields are populated with the the external
NTP pool time zones “2.servertech.pool.ntp.org” and “1.servertech.pool.ntp.org” as the default for new
PRO2 units that have not yet been time set. To edit the host fields, type the desired hostname/IP address
in the Primary/Secondary Host fields.
3. From the Local GMT Offset drop-down menu, select the extended local offset hours and provide minutes.
The GMT offset supports all standard international time zones from -12:59 to +14:59. The GMT offset can
be set in minutes to accommodate partial-hour time zones.
4. To enable Daylight Saving Time (DST), check the Enable box.
5. From the DST Start/End drop-down menus, set the start/end date/time options.
6. Click Apply.
Network > Syslog
The Syslog page supports RFC3164 and RFC5424 compliance and the configuration for standard message
logging to enable offline storage and viewing of firmware log messages and system events.
To configure the Syslog server:
1. Host 1/Host2: Set the Syslog server address by typing the hostname/IP address in the Host1 and/or Host2
field(s). Both IPv4 and IPv6 IP address formats are allowed.
2. Port: When Syslog support is enabled, the Syslog server responds to requests on the default Syslog port
number 514 as displayed on the page. If necessary, edit the port number.
3. Debug Messaging: To enable debug messaging in the Syslog debug log, check the Enable box.
4. Protocol: From the drop-down menu, select the RFC protocol that determines behavior of the Syslog server
and message transmission
5. Click Apply.