Server Technology switched pro2 User Manual - page 152
Switched PRO2 – User Guide
Using the Command Line Interface (CLI)
•
152
set access
Sets user access configurations.
Command Syntax
set access button [disabled | enabled]
set access clitimeout
set access localadmin [required | optional]
set access logorder [newest | oldest]
set access method [localonly | ldaponly | ldaplocal | radiusonly | radiuslocal |
tacacsonly | tacacslocal]
set access prompt
set access startupstick [disabled | enabled ]
set access strongpw [optional | required]
set access webloglen
set access webtimeout
Parameters
The set access command uses the following parameters:
button
Sets if the Configuration Reset button can reset the system
configuration.
clitimeout
Set the CLI session idle time before automatic logout [1-1440
minutes].
localadmin
Removes the restriction to not allow the last local administrator to be
removed when remote authentication (LDAP, TACACS+, or RADIUS)
is in use.
logorder
Sets the default order of the system log when displayed.
method
Sets the allowed access methods for users.
prompt
Sets the system CLI prompt (0-32 characters).
startupstick
Enables/disables the Startup Stick tool for mass PDU configuration.
strongpw
Sets if strong passwords are required for local users.
webloglen
Sets the number of log entries per page when viewing the log on the
Web [10-250 entries].
webtimeout
Sets the Web session idle time before automatic logout [1-1440
minutes].
Sub-Parameters
The set access command uses the following sub-parameters:
localonly
Local authentication only.
ldaponly
Authentication using only the configured LDAP servers.
ldaplocal
Authentication using the configured LDAP servers, then locally if no
LDAP match is found.
radiusonly
Authentication using only the configured Radius servers.
radiuslocal
Authentication using the configured Radius servers, then locally if no
Radius match is found.
tacacsonly
Authentication using only the configured TACACS servers.
tacacslocal
Authentication using the configured TACACS+ servers, then locally if
no TACACS+ match is found.