Server Technology switched pro2 User Manual - page 168
Switched PRO2 – User Guide
Using the Command Line Interface (CLI)
•
168
Parameters
The set outlet command uses the following sub-parameters:
script delay
Sets the time to wait after the script has executed to outlet state
change. 1-15 seconds.
shutdown delay
Sets the time to wait after the shutdown notification to host before outlet
state change. Valid range is 1-900 seconds.
on
Sets outlet to sequence on after system boot.
off
Sets outlet to remain off after system boot.
last
Sets outlet to match its last state prior to system boot after system boot.
alarmhi
Sets high alarm value.
alarmlo
Sets low alarm value.
warnhi
Sets high warning value.
warnlo
Sets low warning value.
min
Command Access
Admin level only