Server Technology switched pro2 User Manual - page 161
Switched PRO2 – User Guide
Using the Command Line Interface (CLI)
•
161
set ipv4, set ipv6
Sets IPv4 and IPv6 configuration values.
Command Syntax
set ipv4 address
set ipv4 gateway
set ipv4 subnet
set ipv6 address
set ipv6 gateway
set ipv6 prefix
Parameters
The set ipv4 and set ipv6 commands use the following parameters:
Ipv4 address
Uses the format of XXX.XXX.XXX.XXX, where XXX=0-255.
Ipv6 address
Uses the format of XXX.XXX.XXX.XXX.XXX.XXX.XXX.XXX, where
XXXX=0-0xFFFF.
Ipv6 CIDR prefix
Uses the format of /0-64.
Command Access
Admin level only; no access in Demo mode
set ldap
Sets LDAP configuration values.
Command Syntax
set ldap bind [simple | tls | md5]
set ldap binddn
set ldap bindpw
set ldap groupattr
set ldap groupsearch basedn
set ldap groupsearch [disabled | enabled]
set ldap groupsearch useattr
set ldap primary
set ldap secondary
set ldap port
set ldap userbasedn
set ldap userfilter
Parameters
The set ldap command uses the following parameters:
bind
Sets the bind method for the LDAP server.
binddn
Sets the distinguished name (DN) for the bind.
bindpw
Sets the password for the bind.
groupattr
Sets the user class distinguished name (DN) or names of groups a user
is a member of.
groupsearch
Sets the bind to search groups for the username in addition to
searching the usernames for its list of group memberships.