Server Technology switched pro2 User Manual - page 172
Switched PRO2 – User Guide
Using the Command Line Interface (CLI)
•
172
Sub-Parameters
The set sensor command uses the following sub-parameters:
alarmhi
Sets high alarm value.
alarmlo
Sets low alarm value.
warnhi
Sets high warning value.
warnlo
Sets low warning value.
min
Command Access
Admin level only
set snmp
Sets SNMP configuration values.
Command Syntax
set snmp iprestrict [none | trapdests]
set snmp syscontact
set snmp syslocation
set snmp sysname
set snmp trap dest1
set snmp trap dest2
set snmp trap format [v1 | v2c | v3]
set snmp trap repeat
set snmp v2 [disabled | enabled]
set snmp v2 [getcomm | setcomm | trapcomm]
set snmp v3 [disabled | enabled]
set snmp v3 [roauth | rwauth] [none | md5 | md5des]
set snmp v3 [roauthpass | rwauthpass] {password} verify password}
set snmp v3 [roprivpass | rwprivpass] {password} {verify password}
set snmp v3 [rousername | rwusername | trapusername]
Parameters
The set snmp command uses the following parameters:
iprestrict
Sets to only allow to trap destinations to have SNMP access
syscontact
System contact string. 0-63 characters.
syslocation
System location string. 0-63 characters.
sysname
System name string. 0-63 characters.
trap
Sets trap notification options.
v2
Sets to allow access with SNMPv2.
v3
Sets to allow access with SNMPv3.