Server Technology switched pro2 User Manual - page 85
Switched PRO2 – User Guide
Using the Web Interface
•
85
What Data Does Trending Measure?
REQUIREMENTS
For the Trending feature to occur and display (for viewing only) on the PRO2 GUI at System > Trending, SNTP
must be enabled to keep track of when daily measurements are taken.
Certain measurements for PIPS and POPS (if POPS is present) are tracked by the Trending feature:
For all PIPS cords/phases/lines, the following measurements are tracked:
• Phase voltage
• Line current
• Cord watts
• Cord power factor
WHAT IS MEASURED?
For all POPS outlets, the following measurements are tracked:
• Current
• Watts
• Power factor
ADDITIONAL TRACKED METRICS
For all of the above PIPS/POPS measurements, the following metrics will also be tracked:
• Minimum measurement
• Maximum measurement
• “In-use average” measurement
Note: PIPS is a standard feature on all PRO2 units, but if the unit does not have POPS, then only the PIPS
measurements will be tracked
.
REQUIREMENTS
For the Trending feature to occur and display (for viewing only) on the PRO2 GUI at System > Trending, SNTP
must be enabled to keep track of when daily measurements are taken.
Certain measurements for PIPS and POPS (if POPS is present) are tracked by the Trending feature:
For all PIPS cords/phases/lines, the following measurements are tracked:
• Phase voltage
• Line current
• Cord watts
• Cord power factor