Server Technology switched pro2 User Manual - page 170
Switched PRO2 – User Guide
Using the Command Line Interface (CLI)
•
170
Parameters
The set port command uses the following parameters:
baud/speed
Sets the number of symbols per second of the serial port.
dsrcheck
Sets to use DSR before making a serial connection.
timeout
Sets the connection idle timeout for pass-thru connections to this port.
0-60 minutes (default 5 minutes).
Command Access
Admin level only
set radius
Sets Radius server configuration values.
Command Syntax
set radius [primary | secondary] port
set radius [primary | secondary] retries
set radius [primary | secondary] host
set radius [primary | secondary] secret
set radius [primary | secondary] timeout
Parameters
The set radius command uses the following parameters:
primary
Sets the first Radius server.
secondary
Sets the second Radius server.
port
Sets the port for Radius sever connections. 1-65535 (default 1812).
retries
Set the maximum retry count for the Radius server. 0-10 (default 2).
host
Sets the Radius server hostname. 0-63 characters.
secret
Sets the shared secret value for the Radius server. 0-48 characters.
Note: The secret that was set for the primary server will not be cleared
when setting the secret for the secondary server, and vice versa.
timeout
Sets the connection timeout for the Radius server. 1-30 seconds
(default 5 seconds).
Command Access
Admin level only; No access in Demo mode