Server Technology switched pro2 User Manual - page 17
Switched PRO2 – User Guide
Installing the PRO2
•
17
Attaching the Link Unit
Connect the PRO2 link unit with the provided 6P6C crossover cable at the link port on the PRO2 unit. The overall
length of the crossover cable should not exceed 25 feet.
Connecting to the Power Source
On PRO2 units with a rating
≥ 24 A, the input power cord is attached to the base of the unit. On PRO2 units with a
total maximum output
power source.
To attach a power cord to the unit:
1. Plug the female end of the power cord firmly into its connector on the PRO2.
2. If using the Retention Bracket Assembly (Part No. KIT-0016), use a screwdriver to tighten the two screws
on the retention bracket.
To connect to the power source:
1. Plug the male end of the power cord into the AC power source.
Connecting Devices
To avoid the possibility of noise due to arching:
1. Keep the on/off switch on the device in the off position until after it is plugged into the outlet.
2. Connect the devices to the PRO2 outlets.
Note: Server Technology recommends even distribution of attached devices across all available outlets to
avoid exceeding the outlet, branch, or phase limitations.
Always disconnect ALL power supply cords before opening to avoid electrical shock.
Afin d’éviter les chocs électriques, débranchez TOUTES les cables électrique avant d’ouvrir
Vor dem Offnen immer Netzleitung abziehen um elektrischen Schlag zu vermeiden.
Connecting the Sensors
The PRO2 is equipped with two mini RJ11 temperature/humidity ports for attachment of the temperature/humidity
sensors. Attach the mini RJ11 plug of the sensor(s) to the appropriate temperature/humidity port.
Connecting to the Unit
Connection can be made with a serial (RS232) port or with an Ethernet port, as described:
For the Serial (RS232) Port:
The PRO2 is equipped with an RJ45 serial RS-232 port
– for attachment to a PC or networked terminal server –
using the supplied RJ45-to-RJ45 crossover cable and the RJ45-to-DB9F serial port adapter, as required.
For the Ethernet Port:
The PRO2 is equipped with an RJ45 10/100Base-T Ethernet port for attachment to an existing network. This
connection allows access to the PRO2 unit via Telnet or Web.