Server Technology switched pro2 User Manual - page 25
Switched PRO2 – User Guide
Getting Started with the Firmware
•
25
Viewing Network Status
You can obtain the IPv6 network status through the firmware Web Interface or Command Line Interface (CLI). For
the CLI, use the show network command as follows:
Switched CDU: show network
Network Configuration
State: Static IPv4 Network: Dual IPv6/IPv4
Link: Up Negotiation: Auto
Speed: 100 Mbps Duplex: Full
MAC: 00-0A-9C-60-0029
AutoCfg IPv6: FE80::20A:9CFF:FE60:29/64
IPv4 Address: 10.1.2.65 Subnet Mask: 255.255.0.0
IPv4 Gateway: 10.1.1.1
DNS1: 10.1.5.133
DNS2: 10.1.5.134
Static IPv4/IPv6 Settings
IPv6 Address: ::/64
IPv6 Gateway: ::
IPv4 Address: 10.1.2.65 Subnet Mask: 255.255.0.0
IPv4 Gateway: 10.1.1.1
DNS1: 10.1.5.133
DNS2: 10.1.5.134
DHCP Settings
DHCP: disabled
FQDN: enabled [sentry-600029]
Boot Delay: disabled
Static Fallback: disabled
Network Services
FTP Server: enabled Port: 21
FTP Updates: disabled Port: 21
SSH: enabled Port: 22 Auth: Password, Kb-Int
Telnet: enabled Port: 23
HTTP: enabled Port: 80
HTTPS: enabled Port: 443 Installed Cert: Self Generated
User Cert: Disabled Stored Files: None
User Passphrase: (none)
SNMPv1/2: enabled Port: 161 TrapPort: 162
SNMPv3: disabled Port: 161 TrapPort: 162
SPM Access: enabled
Note: The fields IPv4 Address, IPv4 Subnet Mask, IPv4 Gateway, DNS1, and DNS2 are equivalent to existing
PRO2 IPv4 settings except that current network settings and static settings are displayed separately.
This allows you to view both static configuration settings and active network settings that can be obtained
using DHCP. The DNS addresses may be in IPv4 or IPv6 (based on RFC4291) format at this time.