Server Technology switched pro2 User Manual - page 207
Switched PRO2 – User Guide
Appendix A: Product Support Information
•
207
Fuse Retractor, Fuse Access Window, and Fuse Access Cover
The PDU AC power source must be disconnected prior to servicing a unit with the Fuse Retractor,
Fuse Access Window, and Fuse Access Cover
.
Intelligent PDUs with branch circuit sensing will display a flashing FE on the input current LEDs to indicate
Fault Error.
For the fuse retractor, rotate the fuse holder exposing the fuse.
For the fuse access window or cover, remove the screws that secure the plastic cover.
Once the fuses are exposed, carefully remove and replace with a new one of the same size, type, and ratings as the original.
A fuse puller may be needed for fuse access windows and covers.
Reverse these steps after the new fuse(s) is installed.
CAUTION:
• Failure to replace the fuse with the same size, type, and ratings will damage the PDU and the connected and nearby
equipment, and will cause electrical shock, fire, explosion, or injury/death.